Mâm Than SME Model 20/3

Mâm Than SME Model 20/3

Thông Số Kỹ Thuật:

ARM

Designed to compliment our very own Series V tonearm.

SUSPENSION

No sonic footprint, the sub-chassis is hung on 80 strands of rubber in the form of 40 purpose moulded ‘O’ rings. An ingenious method of anchorage allows them to be removed or replaced instantly.

DAMPING

A large centrally placed fluid-damper disciplines sub-chassis movement with a pleasing sense of security when handling records on and off the platter, offering a resistive ground-path for acoustic signals.

In addition to a cartridge’s electrical output, mirror image acoustic signals reacted in the arm and record, will pass into the sub-chassis in the course of dissipation. However the usual closed loop design does not address the problem of their differing phase so in the Model 20/12 the structural interfaces concerned have received special attention to provide paths of the required impedance.

This control of vibration is fundamental to the design of the player and goes much of the way to explaining the stunning tonal and dynamic neutrality that it exhibits.

PLATTER

6.5Kg (14.3lb) platter. The face is machined with a fine scroll found to interface better than a plain surface. A substantial reflex clamp ensures maximum contact with the platter even when severe record warp is present. The sub-chassis/arm mounting board interface is extensionally damped and the mounting board is reversible to allow mounting of nine inch pick-up arms when necessary.

MOTOR

The turntable is driven by a 3 phase, brushless outrunner motor with 8-pole Neodymium magnets and 3 integrated Hall effect sensors and virtually vibrationless by reason of its 2.5 kg (5.5 lbs) weight as well as being isolated on urethane mounts that are adjustable for accurate belt positioning.

SPEED CONTROL

The electronic controller uses a high performance microprocessor, optimised for motor control. Closed loop speed control is implemented using a proportional plus integral (PI) algorithm. Fine pitch speed adjustment allows increments/decrements of +/-0.01% of selected speed. Speed ranges: 33.3, 45 & 78 rpm.

POWER

Mains voltages available are 90-110V, 105-125V and 220-240V 50/60 Hz. Please specify when ordering.

DIMENSIONS & WEIGHT

Dimensions: 440 x 350 x 172mm
Net weight: 31kg (68lb)
Shipping weight: 45kg (100 lbs)